User`s manual

12
2-4 Install Memory
This motherboard provides one 184-pin DIMM (
D
UAL
I
NLINE
M
EMORY
M
ODULES) sites
for memory expansion available to maximum memory size of 1.0GB DDR SDRAM.
• Support 128Mb, 256Mb, 512Mb technologies implemented as x8, x16 devices.
• ECC, Non-ECC DIMMS.
Valid Memory Configurations
Bank 184-Pin DIMM Total Memory
Bank 0, 1 (DDR0) DDR200 /DDR266 DDR SDRAM Module X1
64MB
∼
1.0GB
Total System Memory (Max. 1.0GB) 1
64MB
∼
1.0GB
NOTE!
Make sure the installed memory are DDR266 SDRAM support 133MHz memory
clock, otherwise the system may hang during startup. PC2100/ PC2700 DDR are
recommended.
Generally, installing DDR SDRAM modules to your motherboard is very easy, refer to figure 2-4
to see what a 184-Pin DDR200/DDR266 SDRAM module looks like.
DDR1 (BANK0+BANK1)
NOTE!
When you install DIMM module fully into the DIMM socket the eject tab should be
locked into the DIMM module very firmly and fit into its indention on both sides.
WARNING!
For the DDR SDRAM CLOCK is set at 133MHz, use only DDR266-compliant DDR
Modules. When this motherboard operate at 133Mhz, most system will not even boot if
non-compliant modules are used because of the strict timing issues, if your SDR Modules
are not DDR266-compliant, set the DDR SDRAM clock to 100MHz to ensure system
stability.
F