User manual

SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 545
Copyright © 2010, Systium® Technologies, LLC
PN: 91004-03
NOTE
The 3.5" peripheral carrier supports two 1" high devices or one 1.6'
high device. For a second 1" high peripheral please repeat steps 3 and
4 before installing the assembly into the chassis.
Connect Peripheral Cables
1. Connect the cables supplied with the motherboard and/or
installed peripheral devices. Care should be given to ensure the
cables do not block airflow within the chassis and are routed
cleanly to facilitate future system maintenance. Refer to
assembly instructions for the specific motherboard being installed
for a figure showing an example of cable routing.
2. Connect the power cables to the peripherals. The various
peripherals are connected as follows:
PERIPHERAL LOCATION
POWER CONNECTOR
5.25” PERIPHERALS
POWER CABLE WITH 3 STD
PERIPHERAL CONNECTORS
3.5” EXTERNAL PERIPHERALS
POWER CABLE WITH 1 MINI AND 2
STD PERIPHERAL CONNECTOR
3.5” INTERNAL PERIPHERALS
POWER CABLE WITH 2 PERIPHERAL
CONNECTORS
PCI-E VIDEO CONNECTOR
POWER CABLE WITH 6 PIN
CONNECTOR
Install Front Bezel
1. Remove any plastic filler panels required for access to
installed external peripherals. The bezel comes with the
top 5.25” and top 3.5” external peripheral fillers
removed.
2. Position the clips on the outside of the bezel into the
corresponding holes in the front of the chassis. Carefully
rotate the bezel towards the chassis until the clips are
fully inserted into the chassis. Refer to Figure 18
3. Secure the 5.25” external peripheral to the chassis with
the supplied mounting screw. Refer to Figure 19
Install Cover Lock Tab
NOTE
The Model 545 utilizes a power supply with an Energy Hazard on the
12V circuit. Compliance with CE requires installation of the cover
lock tab and a lock or the use of the 6-32 TORX screw to secure the
top cover.
1. Locate the locking tab and mounting screw in the
accessory package.
2. Position the locking tab in the notch on the right rear
edge of the chassis. Secure the locking tab to the
chassis using the screw supplied. Refer to Figure 20.
FIGURE 18
FIGURE 19
FIGURE 20