User manual

SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 545
Copyright © 2010, Systium® Technologies, LLC
PN: 91004-03
Installing a 5.25” External Peripheral
(Lower Bay)
NOTE
It is recommended that the lower bay only be used for an external
peripheral after the middle and top bays have been used. The lower
bay uniquely supports internal or external peripherals.
1. Configure any jumpers or switch settings required by the
peripheral. Refer to the peripheral's user manual for
specific instructions.
2. Remove the built-in EMI shield by placing a flat blade
screwdriver in the hook on the front of the shield. The
shield can then be rotated carefully to break the
mounting slips. Completely remove the EMI shield from
the chassis and dispose of the EMI Shield. Refer to
Figure 16.
3. Position the peripheral in the bay with the mounting
peripheral mounting screw holes matching the mounting
holes in the chassis. Secure the peripheral to the
chassis with four of the mounting screws supplied.
Installing a 5.25” Internal Peripheral
The Model 545 is designed to support mounting of a 5.25”
internal peripheral in the lower 5.25” bay. While it is possible to
physically mount an internal peripheral in the middle or top bay
the EMI shield will not fit correctly due to the mounting rails.
1. Remove the left cover if not removed earlier. Refer to
the section "Removing a Side Cover" for instructions.
2. Determine if the peripheral can be installed without
removing the front EMI shield. If the EMI shield must be
removed to install the peripheral then an EMI shield
must be installed after installing the peripheral. A 5.25”
EMI shield is not supplied with the Model 545 and must
be ordered separately from Systium.
3. Remove the built-in EMI shield by placing a flat blade
screwdriver in the hook on the front of the shield. The
shield can then be rotated carefully to break the
mounting clips. Completely remove the EMI shield from
the chassis and dispose of the EMI Shield. Refer to
Figure 15
4. Configure any jumpers or switch settings require by the
peripheral. Refer to the peripheral's user manual for
specific instructions.
5. Position the peripheral in the bay with the mounting
peripheral mounting screw holes matching the mounting
holes in the chassis. Secure the peripheral to the
chassis with four of the mounting screws supplied. Refer
to Figure 14 & 16
6. Install the EMI shield if the built-in EMI shield was
removed.
NOTE
Failure to install an EMI shield for a 5.25 internal peripheral can
result in EMI leakage that will result in the computer system not
meeting the product's EMC compliance.
Installing a 3.5” Internal Peripheral(s)
1. Remove the screw securing the 3.5” carrier to the
chassis. Refer to Figure 16
2. Grab the edge of the carrier and slide the carrier away
from the chassis. Slide the carrier outwards until it is
fully disengaged from the chassis. Refer to Figure 16
3. Configure any jumpers or switch settings required by the
peripheral. Refer to the peripheral's user manual for
specific instructions.
4. Insert the 3.5” peripheral (HD Shown) into the carrier.
The power and signal connectors should be oriented
towards the rear of the chassis once the carrier is
installed. Align the 3-5” peripheral mounting screws with
the mounting holes in the carrier. Secure the peripheral
to the carrier using the supplied mounting screws. Refer
to Figure 17
5. Install the carrier/peripheral assembly into the chassis
by reversing the steps 2 and 1.
FIGURE 15
FIGURE 16
FIGURE 17