User manual

SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 545
Copyright © 2010, Systium® Technologies, LLC
PN: 91004-03
4. Install the second mounting rail on the opposite side of
the peripheral.
5. If the 5.25” external peripheral is being installed in the
middle bay you must first remove the EMI shield built in
to the chassis. The EMI shield can be removed by
inserting a flat blade screwdriver into the hook in the
EMI shield. The shield can then be rotated carefully to
break the mounting clips. Completely remove the EMI
shield from the chassis and dispose of the EMI Shield.
Refer to Figure 15
6. Line up the mounting rails with the corresponding
guides in the front of the chassis. Insert the peripheral
into the chassis until the front tabs lock to the side of the
chassis. Refer to Figure 10
NOTE
The system must have one 5.25" external peripheral installed or an
EMI shield must be installed. Failure to install a 5.25" external
peripheral or EMI shield can result in EMI leakage that will result in
the computer system not meeting the product's EMC compliance. A
5.25" EMI shield is not supplied with the Model 545 and must be
ordered separately from Systium.
Installing Full Size External 5.25”
Peripheral Devices (Hard Drive Raid Assembly)
The Model 545 is designed to support mounting a 5.25” full size
external peripheral, such as a Hard Drive Raid Assembly, in the
middle and lower 5.25 peripheral bays.
NOTE
Customers installing large wattage peripherals, like a hard drive raid
assembly, should check the system power budget to ensure sufficient
power for the operation of the peripheral. Customers using the 250-
watt configuration may want to install the optional chassis cooling
fan to ensure sufficient cooling for the peripheral.
NOTE
The Model 545 can support a full size peripheral mounted in the top
and middle 5.25 peripheral bays. The middle and lower bays are
recommended due to improved mounting rigidity for the larger
peripheral. It is recommended that the top and middle peripheral bays
be only used for a full size peripheral when no peripheral is installed
in the top bay and no EMI shield is available to block the top bay.
1. Remove the left cover if not removed earlier. Refer to
the section “Removing a Side Cover” for instructions.
2. Remove the EMI Shields. The EMI shields can be
removed by inserting a flat blade screwdriver into the
hook in the EMI shield. The shield can then be rotated
carefully to break the mounting clips. Completely
remove the EMI shield from the chassis and dispose of
the EMI shield. Refer to Figure 15.
3. Configure any jumpers or switch settings required by the
peripheral. Refer to the peripheral’s user manual for
specific instructions.
4. Position the mounting rail on the side of the peripheral
(Hard Drive Raid Assembly) as shown in Figure 12. The
mounting rails are installed by pressing the two tabs into
the peripheral’s upper mounting screw holes. Install the
second mounting rail on the opposite side of the
peripheral.
5. Line up the mounting rails with the guides for the middle
bay. Insert the peripheral into the chassis until the front
locking tabs lock to the side of the chassis. Refer to
Figure 13.
6. Install mounting screws in the lower peripheral bay
mounting holes to secure the peripheral directly to the
chassis. Refer to Figure 15 for the position of the holes
on the right side of the chassis. Refer to Figure 14 for
the position of the holes on the left side of the chassis.
FIGURE 11
FIGURE 12
FIGURE 13
FIGURE 14