User manual

SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 545
Copyright © 2010, Systium® Technologies, LLC
PN: 91004-03
Installing a I/O Adapter (Optional)
If an I/O adapter is part of the system configuration the following
instructions should be followed. If no I/O adapter is to be
installed, then this section can be skipped.
1. Remove the screw holding the I/O slot cover for the I/O
slot to be used. Refer to Figure 8 for the location of the
I/O slot covers.
2. To completely remove the I/O slot cover, slide the cover
upwards and away from the back of the chassis.
3. Refer to the I/O adapter manual for any installation or
configuration steps that need to be completed before
installing the I/O adapter into the chassis.
4. Install the I/O adapter. Refer to the Intel BOX
motherboard manual for any motherboard specific
installation instructions. Full-length adapters should be
installed such that the front of the adapter engages the
correct slot in the card guide at the front of the chassis.
Refer to Figure 8
5. Secure the I/O adapter to the chassis by installing the
I/O cover screw removed in step 1.
NOTE
Installation of full-length ISA adapters in the bottom slot require
Systium Part # 54536-00 to provide a front card guide.
Installing a 3.5” External Peripheral(s)
(Floppy)
NOTE
The system must have one 3.5" external peripheral installed. Failure
to install a 3.5" external peripheral can result in EMI leakage that
will result in the computer system not meeting the product's EMC
compliance.
1. Configure any jumpers or switch settings required by the
peripheral. Refer to the peripheral's user manual for
specific instructions.
2. Locate the 3.5” external peripheral mounting rails in the
integration kit. The 3.5” mounting rails are the smaller of
the two types of rails supplied.
3. Position the mounting rails on the side of the peripheral
(floppy) as shown in Figure 9. Using the supplied M3
screws, attach the mounting rail to the peripheral.
NOTE
The mounting rails are marked with a "F" for the floppy mounting
screw location and a "H" for the LS120 drive mounting screw
location.
4. Install the second mounting rail on the opposite side of
the 3.5” peripheral.
5. Line up the mounting rails with the corresponding
guides in the front of the chassis. Insert the peripheral
into the chassis until the front tabs lock to the side of the
chassis. Refer to Figure 10
NOTE
If a second 3.5" external peripheral is installed you must first remove
the EMI shield built in to the chassis. The EMI shield can be removed
by inserting a screwdriver into the hook in the EMI shield.
The shield can then be rotated carefully to break the mounting slips.
Completely remove the EMI shield form the chassis and dispose of the
EMI Shield. Refer to Figure 15
Installing a 5.25” External Peripheral(s)
(Middle and Top Bays)
1. Configure any jumpers or switch settings required by the
peripheral. Refer to the peripheral's user manual for
specific instructions.
2. Locate the 5.25” external peripheral mounting rails in
the integration kit. The 5.25” mounting rails are the
larger of the two mounting rails supplied.
3. Position the mounting rail on the side of the peripheral
(CD-ROM) as shown in Figure 11. The mounting rails
are installed by pressing the two tabs into the
peripheral's upper mounting screw holes.
FIGURE 9
FIGURE 8
FIGURE 10