User manual

ManualsBrandsBCM ManualsComputer equipmentIN915GVE

SySTIUM

TECHNOLOGIES MotherBoard Ready

System • MODEL 545

PN: 91004-03

4. Place the bezel to the side where it will not get

scratched or damaged before reassembly.

Installing the I/O Shield

1. Locate the I/O shield supplied with the motherboard.

2. Place the lower surface of the I/O shield in the I/O

opening in the rear of the chassis. Ensure the I/O shield

is fully inserted into the opening. Refer to Figure 6

3. Carefully press the top surface of the I/O shield into the

I/O opening. Be careful to only place pressure at the

outer edges of the I/O shield when pressing on the I/O

shield. Check that the I/O shield is fully inserted into the

I/O opening.

NOTE: Failure to properly install the I/O shield can result in EMI

leakage that will result in the computer system not meeting the

product's EMC compliance.

Installing the Motherboard

1. Specific motherboards may require the installation of a

screw-in standoff(s) in the chassis base to mount the

motherboard to. The standoff(s) are included with the

integration kit.

2. Following the instructions supplied with the

motherboard, install the CPU and memory. Ensure that

the recommended ESD protection guidelines are

followed.

3. Place the motherboard on the mounting supports.

Carefully slide the motherboard towards the rear of the

chassis to engage the motherboard connectors into the

I/O shield openings. Refer to the assembly instructions

for the motherboard being installed for a figure of the

correct installation of the motherboard into the I/O

shield.

4. Using the mounting screws supplied, mount the

motherboard to the chassis. Ensure that the

motherboard is fully inserted into the I/O shield while

being tightened into place. Check that the fingers on the

I/O shield are in contact with the connectors.

NOTE: Failure to ensure the fingers are touching the connectors

can result in EMI leakage that will result in the computer system not

meeting the product's EMC compliance.

5. The power supply supports the connection of the fan

monitor cable to one of the motherboard fan connectors.

Refer to the assembly instructions for the specific

motherboard being installed for the correct installation of

the power supply fan monitor cable.

NOTE: Connection of the power supply fan monitor cable is

optional. The cable can be left unconnected, placed cleanly inside the

chassis.

6. Connect the front panel connectors to the motherboard.

Refer to the motherboard manual for the correct

positions. Refer to assembly instructions for the specific

motherboard being installed for a figure of the correct

installation of the front panel connectors.

7. Connect the ATX and ATX-12V power connectors to the

motherboard. Refer to the motherboard specific

assembly instructions for any additional motherboard

power connections.

Installing a PCI-E Video Adapter (Optional)

If the motherboard does not support a built-in video adapter or

the built-in video adapter is not being used, you must install a

video adapter in the slot provided.

1. Refer to motherboard manual for the location of the PCI-

E video slot. Remove the screw holding the I/O slot

cover.

2. To completely remove the I/O slot cover, slide the cover

upwards and away from the back of the chassis.

3. Refer to the video adapter manual for any installation or

configuration steps that need to be completed before

installing the adapter into the chassis.

4. Install the video adapter. Refer to the motherboard

manual for any motherboard specific installation

instructions.

5. Secure the video adapter to the chassis by installing the

I/O cover screw removed in step 1.

FIGURE 5

FIGURE 6

FIGURE 7