User manual

SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 545
Copyright © 2010, Systium® Technologies, LLC
PN: 91004-03
BULK PACKAGE
Please re-cycle the packaging. None of the bulk pack packaging
is designed for reuse when shipping to the end customer.
CONTENTS
The Model 545 MotherBoard Ready System product contains
the following:
• Model 545 Chassis with Power Supply Installed
• North American Compliant Power Cord
• Integration Kit
• Quickstart Guide. (This manual must be included in
shipment to the End User.)
• Manual
Removing a Side Cover
1. Remove the plastic bag protecting the chassis. Save the
bag for shipping the assembled computer.
FIGURE 1
2. Remove the two screws securing the right
cover (As viewed from the rear of the chassis) to the
chassis. Refer to Figure 1
FIGURE 2
3. Using the handhold in the cover slide the cover toward
the rear of the chassis. The cover should move
approximately 1 inch. Refer to Figure 2
4. Rotate the top of
the cover away
from the chassis
and then pull the
side cover
upwards and
away from the
chassis. Refer to
Figure 3.
5. Place the cover
to the side where
it will not get
scratched or
damaged before
reassembly.
NOTE
The same steps are followed for the left cover. The left cover only
needs to be removed for installation of a peripheral in the lower 5.25”
bay. If the left cover is not removed then care must be taken not to
scratch or damage the cover when assembling the system.
Removing the Front Bezel
The front bezel must be removed to install a 5.25” or 3.5”
external peripheral.
1. Locate the two bezel clips at the right front face of the
chassis. Refer to Figure 4
2. Carefully push the clips towards the center of the
chassis until the clips are free of the chassis and can be
pushed out of the chassis towards the front.
3. Carefully rotate the bezel away from the right front of the
chassis. This will disengage the mounting clips on the
left side of the bezel. Refer to Figure 5
FIGURE 4
FIGURE 3