User manual

SySTIUM

TECHNOLOGIES MotherBoard Ready

System • MODEL 545

PN: 91334-01

INTEL DG43NB ASSEMBLY INSTRUCTIONS

I/O Shield

The Intel DG43NB uses the Intel I/O shield supplied with the

motherboard.

Installing the Motherboard

STANDOFF INSTALLATION

Install two brass standoffs, included in the chassis integration kit,

in the locations shows below in Figure 1.

HEATSINK INSTALLATION

1. Install the CPU following the instructions provided with

the CPU.

2. Insert the heat sink support bracket into the

motherboard from the underside of the motherboard.

The standoffs on the bracket

NOTE

Make sure the top surface of the heatsink support bracket has the

Mylar insulatator. Failure to have the insulator in place may cause

motherboard disruption.

3. Turn the motherboard over while holding the support

bracket in place. Place the new heat sink mount on the

motherboard. Attach the heat sink using the 4 built-in

screws. See Figure 3.

4. Connect the heatsink fan cable to the motherboard.

Refer to Figure 3.

INSTALLATION OF FRONT PANEL CONNECTORS

Figure 1

Figure 2

Figure 3

Please note: The motherboard pictured is not

the DG43NB- . This picture is for visual

reference only.