User manual

I/O Shield

The BCM IN915GVE motherboard uses the I/O shield supplied with

the motherboard. Refer to the main assembly guide for instructions

on installing the I/O shield.

Installing the Motherboard

STANDOFF INSTALLATION

Install two brass standoffs, included in the chassis integration kit, in

the locations shown in the figure 1 below.

HEATSINK INSTALLATION

1. Install the CPU following the instructions provided with the CPU.

2. Insert the heat sink support bracket into the motherboard from

the underside of the motherboard. The standoffs on the bracket

are inserted into the holes in the motherboard. Refer to Figure 2

FIGURE 2

NOTE

Make sure the top surface of the heat sink support bracket has the

mylar insulator. Failure to have the insulator in place will result in

the board not working.

3. Turn the motherboard over while holding the support bracket in

place. Place the new heat sink mount on the motherboard.

Attach the heatsink using the 4 built-in screws. See Figure 3

FIGURE 3

4. Connect the heatsink fan power cable to the motherboard. Refer

to Figure 3

INSTALLATION OF FRONT PANEL CONNECTORS

BCM IN915GVE ASSEMBLY INSTRUCTIONS

PN: 91229-00

SySTIUM

TECHNOLOGIES MOTHERBOARD READY

SYSTEM • MODEL 545