User manual

I/O Shield

The Intel S3000AH motherboard uses the Intel I/O shield supplied

with the motherboard. Refer to the main assembly guide for

instructions on installing the I/O shield.

Installing the Motherboard

STANDOFF INSTALLATION

The S3000AH does not require installation of the brass stand-offs

included in the integration kit. These parts can be disposed of.

HEATSINK INSTALLATION

1. Install the CPU following the instructions provided with the CPU.

2. Insert the heat sink support bracket into the motherboard from

the underside of the motherboard. The standoffs on the bracket

are inserted into the holes in the motherboard. Refer to Figure 2

NOTE

Make sure the top surface of the heat sink support bracket has the

mylar insulator. Failure to have the insulator in place will result in

the board not working.

FIGURE 2

3. Turn the motherboard over while holding the support bracket in

place. Place the new heat sink mount on the motherboard.

Attach the heatsink using the 4 built-in screws. See Figure 3

FIGURE 3

4. Connect the heatsink fan power cable to the motherboard. Refer

to Figure 3

INSTALLATION OF FRONT PANEL CONNECTORS

S3000AH ASSEMBLY INSTRUCTIONS

PN: 91249-00