User manual

SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 545
Copyright © 2010, Systium® Technologies, LLC
PN: 91004-03
Install Side Cover
NOTE
Before installing the right side cover please check that all cables are
connected and no tools, screws or accessories are left inside the
chassis.
1. Position the lower groove in the side cover to fit onto the
lower edge of the chassis. Refer to Figure 21.
2. Close the side cover so as to be flush with the chassis.
3. Slide the cover towards the front of the chassis. Ensure
that all the mounting clips on the cover are fully
engaged with the chassis. If the optional locking tab is
installed, ensure that the tab is inserted into the slot in
the cover.
4. Secure the cover to the chassis with the two screws
removed when the cover was originally removed.
NOTE
To install the left cover the same steps are followed except there is no
locking tab on the left side of the chassis.
Power up the System
1. Connect the keyboard, mouse, monitor and any other
required peripheral for the correct operation of the
computer. Refer to the Quick Start section in this
manual for assistance in connecting the peripherals to
the computer.
2. Turn on the computer by pressing the power switch on
the front panel. Refer to the Quick Start Section of this
manual for more information.
3. Verify the operation of the POWER ON indicator on the
front panel. The LED should glow constantly when the
computer is turned on. Verify that the floppy LED turns
on when the system resets the floppy drive during the
POST. Verify the operation of the hard drive LED on the
front panel. The LED should turn on when the POST
resets the hard drive or attempts to boot the computer.
Correct any problems detected during the initial power
up phase.
4. Test the complete operation of the computer using a
known good computer functional test program such as
Intel’s Test view. Install any required operating system
or application software.
NOTE
The computer must have all the required warning and information
lights functioning before shipping to the end user.
5. Disconnect the computer from the peripherals used during the
testing phase. Package the computer using the original
packaging (Single Pack Only).
NOTE
You must include the End User Quick Start
manual in the shipment to the customer to
maintain Regulatory Compliance.
NOTE
If the computer was assembled from a bulk pack Motherboard Ready
product the computer must be packaged in a Single pack box or
similar packaging before being shipped to the end user.
FIGURE 20