User`s manual

Installation

order to prolong the lift of the system’s power supply. See the figure below.

6) Speaker connector: SPKR

This 4-pin connector connects to the case-mounted speaker. See the figure below.

7) Power LED: POWER LED

The Power LED is light on while the system power is on. Connect the Power LED from

the system case to this pin.

8) Power switch: PW BTN

This 2-pin connector connects to the case-mounted power switch to power ON/OFF the

system

System Case Connections

GND

Turbo LED

GND

Reset SW

VCC

GND

Turbo SW

Speaker

VCC

GND

Power LED

GND

VCC

IDELED

PW BTN

SMI SW

9) Wake On-LAN Headers (3-pin): WOL

This connector connects to a LAN card with a WAKE ON-LAN output. This connector will

power up the system when a wake up signal is received through the LAN card.