User`s manual

4
EASY INSTALLATION
E
E
A
A
S
S
Y
Y
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
Easy Installation Steps
The following “Easy Installation” steps are for
users accustomed to the assembly of a computer
system. For those individuals requiring more
specific information please refer to the more
detailed descriptions located within the latter
chapters of this manual. Note: You must keep
your power cable unplugged until the following
installation steps are completed.
Getting Start:
Touch a grounded metal surface to release static electricity
stored in your body before unpacking your motherboard. For
details please refer to Precaution section in Chapter 3.
Install the CPU by correctly aligning the CPU with the slot1 as
noted in the motherboard diagram. Once aligned, press down on
the CPU gently but firmly and lock it. Next, install the 3.3 volt
unbuffered SDRAM into the 168 pin
DIMMs. See Sec. 3.2 & Sec. 3.3.
Set CPU speed in according to Sec.3.2.
After completing the above steps, install any expansion
Cards( PCI, ISA) into riser card and have the riser card installed
firmly into the slot for riser card on board. See Sec. 3.4.
Plug in all cables included in the package except for the
power cord. Please see Sec. 3.5.
Please recheck all steps to ensure no mistakes
have been made and then plug in the power cord
and turn on the power to enter the BIOS setup, Chapter 4.
Release
Static Electricity
Couple
Connectors Of
HDD, FDD…
Install All
Expansion Slots
Set Jumpers of
CPU
Insert CPU &
RAM