User`s manual

3.INSTALLATION

BIOS and the operating system’s APM driver is loaded, the system can enter the

sleep (standby) mode in one of the following ways:

♦ Optional front panel sleep/resume button

♦ Prolonged system inactivity using the BIOS inactivity timer feature

(Section 4.5)

The 2-pin header supports a front panel sleep/resume switch, which must be a

momentary SPST type that is normally open

Power Switch (2-pin)

This connector supports the ATX case-mounted Power Switch, which in turn

supports System Suspend function. When the BIOS sets the Power Button

function to “Delay 4 sec.”, the system can be set to the suspended mode once you

push the power switch for no longer then 4 seconds. If the power switch is

pushed down for over 4 seconds the system will be totally Power Off. When the

BIOS setting sets the Delay 4 second to “Instant-off”, then Power Switch function

work as regular power switch.

Power LED (2-pin)

This header can be connected to a LED that will light when the computer is

powered on.

Speaker Connector (4-pin)

It is used to drive a chassis-mounted speaker if desired.