User`s manual

- 13 -

Installation

3.4 System Memory (DRAM)

3.4.1 DIMM (Dual Inline Memory Module)

The motherboard features two 168-pin DIMM sockets, share memory module. If you have

only one DIMM RAM, note that you must insert it into DIMM 1. You can configure the

system memory size from 16MB to 1GB in a variety of ways by using different combinations

of the two 168-pin DIMMs.

3.4.2 Installation Procedure

Step1:

Make sure

Pin 1 of the DIMM match

with pin 1 of the DIMM socket.

Step2:

Insert the DIMM module into the DIMM

socket vertically. After inserting the

DIMM module completely into the

socket, push up on the socket latches

securing the DIMM into place. If the pin

1 of the DIMM module does not line up with pin 1 of the socket, the DIMM module

will not be inserted correctly into the socket.

Be careful not to misfit the DIMM into DIMM socket in wrong direction. This module can be

inserted into the socket only one way. To release the memory module, push both latches

down and carefully rock the module forward and backward while slowly lifting it upward.

3.4.3 DIMM Combinations

Each DIMM socket can be inserted with 8MB, 16MB, 32MB, 64MB, 128MB, 256MB, and

512MB. For example, the following figure shows you one way to insert your DIMMs.

16MB 64MB

32MB

256MB

DIMM 1

Select

Empty 16MB

64MB

32MB

256MB

DIMM 2

128MB

512MB

Select DIMM 1: 32MB

DIMM 2: 16MB

Total

32+16=48MB

Select 1 out of 6 Choices (16MB, 32MB, 64MB, 128MB, 256MB, and 512MB) in DIMM 1.

Then, repeat again in DIMM 2 for 7 choices (Empty, 16 MB, 32 MB, 64 MB, 128MB,

256MB, and 512MB).