User`s manual

40
Video Off Method
Determines the manner in which the monitor is blanked.
Blank Screen System: only writes blanks to the video buffer.
V/H SYNC+Blank: System turns off vertical and horizontal synchronization ports and
writes blanks to the video buffer.
DPMS: Display Power Management Signaling (DPMS) mode uses the software supplied
for your video subsystem to select video power management values.
Video Off In Suspend
Determines whether the video is turned off under Suspend Mode.
Suspend Type
Selects the behavior of the CPU after it enters Suspend Mode.
Stop Grant: CPU goes into idle mode during power saving mode
PwrOn Suspend: CPU and system remain powered on in suspend mode
MODEM Use IRQ
Name the interrupt request (IRQ) line assigned to the modem (if any) on your system.
Activity of the selected IRQ always awakens the system.
Suspend Mode
After the selected period of system inactivity, all devices except the CPU shut off.
HDD Power Down
After the selected period of drive inactivity, the hard disk drive powers down while all
other devices remain active.
Soft-Off by PWR-BTTN
When Enabled, turning the system off with the on/off button places the system in a very
low-power-usage state, with only enough circuitry receiving power to detect power
button activity or Resume by Ring activity.
Wake-Up by PCI card
When Disabled is selected, the system will ignore any incoming call from the PCI
card/modem. When Enabled is selected, the system will boot up if there’s an incoming
call from the PCI card /modem.
Power On by Ring
An input signal on the Ring Indicator (RI) line (such as a modem) that awakens the
system from the off state.
Resume by Alarm
This function is for setting date and time for your computer to boot up. During Disabled,
you cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm