User`s manual

Power Up By PS/2 Device

Enables the system to be turned on through PS/2 keyboard or mouse.

Hot Key Select

Sets the Hot Key to turn on the system.

Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDC) installed on the system

board and you wish to use it. If you install add-on FDC or the system has no floppy drive,

select Disabled in this field. The settings are: Enabled and Disabled.

Onboard Serial Port 1/2

Select an address and corresponding interrupt for the first and the second serial ports.

Available settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.

UART Mode Select

Selects the mode the UART operates under. Aavailble settings are: Normal, IrDA,

ASKIR, or SCR.

Onboard Parallel Port:

There is a built-in parallel port on the on-board Super I/O chipset that provides Standard,

ECP, and EPP features. It has the following option:

Disabled

(3BCH/IRQ7)/ Line Printer port 0

(278H/IRQ5)/ Line Printer port 2

(378H/IRQ7) Line Printer port 1

Parallel Port Mode

SPP : Standard Parallel Port

EPP : Enhanced Parallel Port

ECP : Extended Capability Port

SPP/EPP/ECP/ECP+EPP

To operate the onboard parallel port as Standard Parallel Port only, choose “SPP.”

To operate the onboard parallel port in the EPP modes simultaneously, choose

“EPP.” By choosing “ECP”, the onboard parallel port will operate in ECP mode

only. Choosing “ECP+EPP” will allow the onboard parallel port to support both the

ECP and EPP modes simultaneously.

ECP Mode Use DMA

If ECP is selected, DMA channel 1 or 3 must be chosen.

PWRON After PWR-Fail

This item allows you to select system power status after power is lost. Available choice:

Off, On, Former-Sts.