User`s manual

35
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector
read/write. If your IDE hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal number of block read/writes
per sector the drive can support.
IDE DMA transfer access
On-Chip Primary PCI IDE
Enables the Primary IDE channel.
IDE Primary Master PIO
Selects the PIO mode for Primary IDE Master. Avalable options are: Auto, Mode
0, Mode 1, Mode 2, Mode 3 or Mode 4.
IDE Primary Slave PIO
Selects the PIO mode for Primary IDE Slave. Avalable options are: Auto, Mode
0, Mode 1, Mode 2, Mode 3 or Mode 4.
IDE Primary Master UDMA
Enables UDMA detection for Primary IDE Master. Available options are: Auto
or Disabled.
IDE Primary Slave UDMA
Enables UDMA detection for Primary IDE Slave. Available options are: Auto or
Disabled.
SATA Mode
Selects mode of operation for SATA function.
IDE - no AHCI, no RAID; SATA drives operate as standard IDE drives.
RAID - AHCI enabled, RAID enabled; Redundant Array of Independent Disks
(RAID) provides features for fault tolerance and/or performance.
AHCI - AHCI enabled, no RAID; Advanced Host Controller Interface (AHCI)
enables advanced Serial ATA features such as Native Command Queuing and hot
plug.
On-Chip Serial ATA
Selects the different modes for the SATA controller.
Disabled: Disables SATA controller
Auto: Auto arrange by BIOS