User`s manual

(8) VGA Connector (15-pin D-Sub) Connector: VGA

VGA is the 15-pin D-Subminiature female connector for display monitor.

(9) Floppy drive Connector (34-pin block): FDD

This connector supports the provided floppy drive ribbon cable. After

connecting the single plug end to the motherboard, connect the two plugs at

other end to floppy drives.

Floppy Drive Connector

Pin 1

FDD

(10) Primary IDE Connector (40-pin block): IDE1

This connector supports the provided IDE hard disk ribbon cable. After

connecting the single plug end to motherboard, connect the two plugs at

other end to your hard disk(s). If you install two hard disks, you must

configure the second drive to Slave mode by setting its jumpers accordingly.

Please refer to the documentation of your hard disk for the jumper settings.

Parallel IDE Connector

Pin 1

IDE1