User`s manual

BIOS Setup

4.9.6 Hard Disk Power Down

Set system inactivity time period before BIOS shutdown IDE drive in APM mode.

4.9.7 Video Off

Set system inactivity time period before BIOS turn off video in APM mode.

4.9.8 Power Button

In case of computer being “hung”: Instant-Off allows the power button to shut down the

system instantly by the push of the button; Delay 4 Sec. allows the power button to shut down

the system after holding the button for 4 seconds.

4.9.9 MODEM Uses IRQ

Determines which IRQ the MODEM can use. The choices are: 3, 4, 5, 7, 9, 10, 11, and N/A.

4.9.10 Wake On LAN

When enable, an input signal from the local area network line will awaken the system from

the soft-off state.

4.9.11 Wake On PME

When enable, BIOS will enable PCI device to drive PME signal to awaken the system.

4.9.12 Wake ON RI

When enable, an input signal from Ring Indicator (RI) line < an incoming call from modem>

will awaken the system from the soft-off state.

4.9.13 PWRON After PWR-Fail

Sets PWRON After PWR-Fail as Last State, on, or off.