User`s manual

Installation

3.4 System Memory (DDR SDRAM)

3.4.1 DDR DIMM (Double Data Rate Dual Inline Memory Module)

The motherboard features support two 184-pin DIMM, share memory module. You can configure the system

memory size from 64MB to 2GB in a variety of ways by using different combinations of the two 184-pin DIMMs.

3.4.2 Installation Procedure

Step1: Make sure Pin 1 of the DDR DIMM match with pin 1

of the DDR DIMM socket.

Step2: Insert the DIMM module into the DIMM socket

vertically. After inserting the DIMM module completely into the

socket, push up on the socket latches securing the DIMM into

place. If the pin 1 of the DIMM module does not line up with pin 1

of the socket, the DIMM module will not be inserted correctly into

the socket.

Be careful not to misfit the DIMM into DIMM socket in wrong direction. This module can be inserted into the

socket only one way. To release the memory module, push both latches down and carefully rock the module

forward and backward while slowly lifting it upward.

3.4.3 DIMM Combinations

Each DIMM socket can be inserted with 64MB, 128MB, 256MB, 512MB and 1GB DDR DIMM. For example, the

following figure shows you one way to insert your DIMMs.

64MB

256MB

128MB

1GB

DIMM 0

Select

64MB

256MB

128MB

1GB

DIMM 1

512MB

Select DIMM 0: 256MB

DIMM 1: 512MB

Total

256+512=768MB

Select 1 out of 5 Choices (64MB, 128MB, 256MB, 512MB and 1 GB) in DDR DIMM 0. Then, repeat again in

DDR DIMM 1 for 6 choices (Empty, 64 MB, 128MB, 256MB, 512MB and 1GB) to go through your own path.