User`s manual

- - 21
Installation
a PCI add-in network interface card (NIC) with remote wakeup capabilities. The remote
wakeup connector on the NIC must be connected to the onboard WOL connector. For Wake
on LAN, the 5-V standby line for the power supply must be capable of delivering 5V at
720mA.
Chassis Intrusion Connector (J28, 2-pin)
This connector is for a chassis designed for chassis intrusion detection. After-market toggle
switches may also be installed to the chassis panel or on any removable components. Two
wires should be available from the chassis to connect to this connector. When any chassis
component is removed, the contact should open and the motherboard will record a chassis
intrusion event. The event can then be processed by software such as LDCM.
FAN 2 Connector (J30, 3-pin)
This connector is used for chassis fan or power fan if needed.
FAN 3 Connector (J19, 3-pin)
This connector is used for system fan or power fan if needed.
CPU Fan Connector (J22, 3-pin)
The CPU may have an attached heatsink and fan; connect the CPU fan assembly power to
this connector.
CD-In Connector (J11, 4-pin, Black)
A connector is available for audio input from CD-ROM drives.
Aux-In Connector (J6, 4-pin, White)
Access the Aux-In connection for audio input from the auxiliary devices.
Telephony Connector (J7, 4-pin, Green)
Access the Telephony connection for audio input from the modem.
BIOS boot block Lock and write protect Header (JP10, JP16 3-pin)
When enabled, the BIOS boot block will be locked.
When enabled, the BIOS write will be locked.
JP10: FWH Boot Block Protect
1-2 Unlock (Default)
2-3 Lock
JP16: FWH Write Protect
1-2 Normal (Default)
2-3 Write Protect