Service manual

Neurodiagnostic Instruments Service Manual
3 - 38 Revision 2/18/05
Serial ATA Hard Drive(s)
Description
The Endeavor CR/VikingQuest desktop systems and
VikingSelect system contain a single hard drive, 80GB
or larger. Physically, the hard drive mounts into a carrier
that is held in place with a single screw.
Removal/Replacement.
CD-RW Drive
Description
The standard desktop systems contain a CD-RW drive.
The Endeavor CR desktop system offers a DVD
±R/RW
drive option. The drive connects to the secondary PATA
port as Master. The CD R/W drive currently in use is the
Sony model 195E. The DVD drive currently in use is
the Plextor PX-708A.
Removal/Replacement
Step Action
1. Remove the computer's top cover.
2. Disconnect the power and data/control
cables from the drive. Note the orientation
of all cables for proper reassembly.
3. Remove the screw that fastens the drive
carrier to the chassis.
4. Pull up on the plastic tab on the back side of
the carrier to rotate the back of the hard
drive upwards.
5. Remove the carrier from the computer. The
hard drive is fastened to the carrier with four
screws.
6. Replace the drive and reassemble the
system.
Serial ATA Hard Drive
Step Action
1. Remove the computer's top cover.
2. Release the computer's front panel by
pressing on the three plastic tabs at the top
of the cover. Remove the cover.
3. Disconnect the power and data/control cable
from the drive. Note the orientation of all
cables for proper reassembly.
4. Remove the carrier tray
5. Holding screw located at the top left side of
the tray. Slide the tray forward to release it
from its holding tabs then lift it upward.
6. Remove the drive from the carrier.
7. Verify the jumper setting on the replacement
drive (normally Master).
8. Replace the drive and reassemble the
system.
Plextor PX-708A DVD Drive