Service manual

Neurodiagnostic Instruments Service Manual
5 - 34 Revision 2/18/05
6. On the Installation Options screen, click on
the software options you want to install. You
need to install the Master Software, the
Licensed Software and Settings, if you do
not have your own settings. The Demo
Software and Demo Data choices are
optional.
If you have customized settings previously
installed on your system, do NOT check
the Install Settings option.
7. When finished making selections, click on
Next.The program prompts you for the
Software License disk.
8. Insert the VikingQuest Software License
disk into the floppy drive and click on Next.
9. On the Software Registration box, type the
serial number listed on the floppy disk
sleeve and click on Next. The program
verifies that the license disk matches the
system serial number.
10. If you selected the Install Demo Software
option on the Installation Options screen,
you will select the demo software you want
to install. If you have a license for an
application, it will be grayed out.
If you don't have a license for an application,
you can place a check mark in front of the
item to install the demo software. Or click
on the Select All button to select all
available applications, then click on Next.
11. If you selected the Install Settings option on
the Installation Options screen, you will
select the settings to be installed. Click on
the desired settings, then click on Next.
Step Action
12. Verify the information listed on the Start
Copying Files box is correct, then click on
Start.
A series of installation and installation
progress messages are displayed.
NOTE:
If VikingSelect program settings exist on the
hard drive, you will see the Overwrite
Settings message.
If this is an initial installation, select Yes to
overwrite the VikingSelect settings listed in
the message, or select Yes to All to
overwrite all VikingSelect settings stored on
the hard drive.
If reloading, select No to keep the original
VikingSelect settings listed in the message,
or select No to All to keep all existing
settings and not overwrite them.
13. When the VikingSelect installation is
completed, the program displays the Setup
complete window. Remove the VikingSelect
Software License disk and the Addendum
CD from the drives.
14. Click on Yes, I want to restart my
computer now, then click on Finish. The
system restarts, then displays the Begin
Logon box.
15. Log on as normal.
16. Be sure to store the installation disks in a
safe place.
Step Action