Service manual

Revision 2/18/05 5 - 31
System Procedures
Reinstall The Console Base
Note: Verify that the console base is unplugged from the
computer before you restart the computer.
Alternate USB Driver Installation
(Loading USB drivers when the VikingQuest
Addendum CD is not available)
NOTE:
Install the VikingQuest software before installing the
Console Base or other USB devices.
NOTE:
Verify that the console base is unplugged from the
computer before you restart the computer.
Step Action
1. Restart your VikingQuest (Start > Shut
Down > Restart the computer), then log on
as Nicolet (there is no password unless you
set one).
2. If VikingQuest does not automatically start,
go to step 3. If VikingQuest opens after
logging on, click on Cancel in the Hardware
Initialization Failed screen, and click on OK
in the Continue in Review Mode screen.
When VikingQuest opens, click on the X in
the upper right corner to close the
VikingQuest program.
3. Plug the USB cable from the console base to
the computer. A Found New Hardware
Wizard window opens.
4. Make sure the first option, Install the
software automatically (Recommended) is
marked.
5. Insert the System Addendum CD into the
CD drive and click on Next.
6. On the Windows Logo testing window, click
on Continue Anyway.
7. When the wizard finishes searching for the
driver, click on Finish.
8. Leave the disk in the drive. If you are
prompted with the Found New Hardware
screen again, click on Next and repeat steps
6 and 7.
9. Turn off the console base.
10. Connect the console base to another USB
port.
11. Turn on the console base.
12. Repeat steps 3 through 10 for any USB port
that may be used.
If the files are not found or you cannot find
your Addendum CD, see the following
section "Alternate USB Driver Installation.
Step Action
1. Restart your VikingQuest (Start > Shut
Down > Restart the computer), then log on
as Nicolet (there is no password unless you
set one).
2. If VikingQuest does not automatically start,
go to step 3. If VikingQuest opens after
logging on, click on Cancel in the Hardware
Initialization Failed screen, and click on OK
in the Continue in Review Mode screen.
When VikingQuest opens, click on the X in
the upper right corner to close the
VikingQuest program.
3. Plug the USB cable from the console base to
the computer. A Found New Hardware
Wizard window opens.
4. Make sure the first option, Install the
software automatically (Recommended) is
marked.
5. Click on Next.
6. On the Windows Logo testing window, click
on Continue Anyway.
7. At the Insert Disk screen, click on OK
without inserting the CD. (If you have the
Addendum CD, see the directions in the
previous section.)
8. On the Files Needed window, click on
Browse.