Service manual

Neurodiagnostic Instruments Service Manual
5 - 30 Revision 2/18/05
8. Type the serial number listed on the floppy
disk sleeve and click on Next. The program
verifies that the license disk matches the
system serial number.
9. If you selected the Install Demo Software
option on the Installation Options screen,
you will select the demo software you want
to install. If you have a license for an
application, it will be grayed out.
If you don't have a license for an application,
you can place a check mark in front of the
item to install the demo software. Or click
on the Select All button to select all
available applications, then click on Next.
10. If you selected the Install Settings option on
the Installation Options screen, you will
select the settings to be installed. Click on
the desired settings, then click on Next.
11. Verify the information listed on the Start
Copying Files box is correct, then click on
Start.
A series of installation and installation
progress messages are displayed.
NOTE:
If VikingQuest program settings exist on the
hard drive, you will see the Overwrite
Settings message.
If this is an initial installation, select Yes to
overwrite the VikingQuest settings listed in
the message, or select Yes to All to
overwrite all VikingQuest settings stored on
the hard drive.
If reloading, select No to keep the original
VikingQuest settings listed in the message,
or select No to All to keep all existing
settings and not overwrite them.
Step Action
12. When the VikingQuest installation is
completed, the program displays the Setup
complete window. Remove the VikingQuest
Software License disk and the Addendum
CD from the drives.
13. Click on Yes, I want to restart my
computer now, then click on Finish. The
system restarts, then displays the Begin
Logon box.
14. Log on as normal.
15. Be sure to store the installation disks in a
safe place.
Step Action