Service manual

Revision 2/18/05 5 - 29
System Procedures
VikingQuest Software Loading Procedure
Introduction
This section covers the steps required to install the
VikingQuest Master Software and Licensed
Applications on your VikingQuest system.
Items Required
The following items are required for a complete
software installation:
• System Addendum CD)
• VikingQuest Software License Disk
This procedure may take up to 15 minutes to complete.
Tips on Performing this Procedure
Successfully
1. If you see a message about a file not being found,
make sure you have the correct disk inserted in the
correct disk drive.
2. Be sure to click on buttons, such as OK and Ye s,
rather than just pressing Enter. The option you
want may not be selected, even if it is the only
option listed.
3. Always restart the system by clicking on Start, then
selecting Shut Down and Restart the computer
(Start > Shut Down > Restart the computer)
unless instructed otherwise.
4. When you see the OS Loader screen after restarting
the system, do not do anything. The system will
display the Begin Logon window within a minute.
5. Install the software with the console base
unplugged from the laptop or CPU.
6. Several new hardware devices may be found on
start up. For each New Hardware Wizard dialog,
click the on Cancel button when prompted.
Procedure
Step Action
1. Restart your VikingQuest (Start > Shut
Down > Restart the computer), then log on
as Nicolet (there is no password unless you
set one)
2. Insert the VikingQuest Addendum CD into
the CD drive. The setup program should
start up automatically. If it does not start,
follow the steps below:
a. Select Start > Run.
b. On the Run box, type the drive letter for
the CD drive.
c. Click on the Browse button.
d. Next, double click on the setup.exe
folder and click on OK.
3. Read the information given on the
VikingQuest Welcome screen, then click on
Next.
4. Read the Software License Agreement, then
click on Ye s .
5. On the Installation Options screen, click on
the software options you want to install. You
need to install the Master Software, the
Licensed Software and Settings, if you do
not have your own settings. The Demo
Software and Demo Data choices are
optional.
If you have customized settings previously
installed on your system, do NOT check
the Install Settings option.
6. When finished making selections, click on
Next.The program prompts you for the
Software License serial number.
7. Insert the VikingQuest Software License
disk into the floppy drive and click on Next.