Service manual

Revision 2/18/05 5 - 27
System Procedures
Endeavor CR Software Loading Procedure
Introduction
This section covers the steps required to install the
Endeavor CR application on the host computer. This
procedure assumes that Windows XP is already resident
on the computer.
Items Required
The following items are required for a complete
software installation:
• Windows 2000/XP Drivers CD (482-636203)
• The System Name and Workgroup and Network IP
address setup for the system
• Printer and accompanying USB cable
• NicVue and Endeavor CR Installation CDs
Before you install Endeavor CR software, disconnect
the computer from the Endeavor CR base unit
(required for Windows XP to properly detect the USB
connection between the computer and base unit)
Procedure.
Load USB Drivers
Step Action
1. Insert the Endeavor CR Installation CD into
the CD or DVD drive. The CD auto-starts
and displays the InstallShield Wizard
window showing a Select Hardware screen.
2. Select either the Desktop or Portable option
then click on Next. A Welcome screen
appears.
3. Click on Next.
The Software License Agreement screen
appears.
4. Click on Ye s to accept the license
agreement. A query panel asks if you wish to
install Endeavor Review software.
5. Select YES or NO and click on Next. The
Installing ... screen appears with a status bar
showing installation progress. When done,
the Install Wizard Complete screen appears.
6. Remove the Endeavor CR disk from the CD
or DVD drive.
7. Click on Yes, I want to restart my
computer, then click on Finish to close the
installation window, then reboot.
Step Action
1. Plug in the USB interface cable from the
base to the laptop.
2. Click on Next. The system...
3. Click on Continue anyway. The system...
4. Click on Browse. Locate and highlight
C:\Windows\System32\Drivers\CyUSB.
5. Click on Open and OK.
6. Click on Finish.
7. Repeat steps 1 to 6 for all the remaining
USB ports on the computer.