Service manual
Neurodiagnostic Instruments Service Manual
5 - 24 Revision 2/18/05
Check Display Settings
Load the Network Driver
Step Action
16. Right click on any open area of the desktop.
A menu opens.
17. Click on Properties. The Display
Properties window opens.
18. On the Settings tab, verify:
Screen Resolution = 1280x1024
or 1024x768 (15” LCD panels only)
Color Quality = Medium (16 bit)
19. Optional: To set the desktop wallpaper to
the VIASYS logo, click on the Desktop tab,
then click on NicPaper.
20. Click on Apply to apply the new display
settings.
21. Click on Ye s to close the confirmation
window.
22. Click on OK to close the Display Properties
window.
Step Action
23. On the Windows desktop, click on
Start>Settings>Control Panel.
24. On the Control Panel window, click on the
Add Hardware icon. The Add Hardware
Wizard opens.
25. On the Welcome screen, click on Next. The
Hardware Wizard checks for components.
26. When you see the message, Is the hardware
connected?, click on Yes, I have already
connected the hardware, then click on
Next.
27. On the list of hardware already installed,
highlight Ethernet Controller. You should
see a yellow exclamation point in front of
this option. This icon means that the driver
is not installed for this device. Click on
Next.
28. On the Completing the Add Hardware
Wizard screen, click on Finish.
29. When you see the message, If your
hardware came with an installation CD or
floppy disk, insert it now, insert the Network
Drivers and Settings CD in the CD drive.
30. Click on Next.
31. On the Completing the Hardware Update
Wizard window, click on Finish.
32. As the driver is installed, you may see a
message about the driver software not
passing Windows Logo testing to verify
compatibility, click on Continue Anyway.
33. When you see the Adaptor Software
installation completed message, click on
Finish.
34. When you see the New network device
installed message, click on the Network
icon to which the message points.
35. On the Network Connections window, open
the Advanced menu, then click on Network
Identification…