Service manual

Neurodiagnostic Instruments Service Manual
5 - 22 Revision 2/18/05
Load and configure application software
This software is used for acquiring and reviewing
patient data.
Load MS Office
Microsoft Word is required for generating reports on the
VikingQuest and VikingSelect applications.
Check folder sharing
Folder sharing is required for networked systems.
Items Required
The following items are required for a complete
software installation:
• Windows 2000/XP Drivers CD (482-636203)
• System Serial Number (attached to the computer
case)
• The System Name and Workgroup
• Network IP address setup for the system
• Customer Data and Settings backups
• NicVue Installation CD
• Endeavor CR, VikingQuest, or VikingSelect
Installation CDs
Windows Configuration
If you are going to load VIASYS software on a new
computer that has been pre-loaded with Windows XP by
the manufacturer, follow these steps.
Some of the following steps pertain directly to the Dell
Latitude D505 laptop computer. If you are loading
software on a different computer, some of the
configuration steps may differ.
Step Action
1. Power up the system. At the Welcome to
Microsoft Windows screen, click on Next to
continue.
2. At the EULA screen, select Yes, I accept it
and click on Next.
3. For the Computer Name on the next screen,
enter EndeavorUser (no spaces) or
VikingUser (no spaces) and click on Next.
4. When asked for the Administrator
password, enter nicolet, confirm the entry,
and click on Next.
5. If the message An internet connection could
not be ... appears, click on Skip.
6. If the message How will this computer
connect... appears, select Local area
network (LAN) and click on Next.
7. At the Setting up a high speed connection
screen, check mark
Obtain IP automatically and
Obtain DNS automatically,
then click on Next.
8. If asked to register with Dell or Microsoft,
select No, not at this time and click on
Next.
9. At the Who will use this computer screen,
enter Nicolet in the Your Name field, then
click on Next.
10. Click on Finish.