Service manual

Neurodiagnostic Instruments Service Manual
5 - 6 Revision 2/18/05
Run Check Disk
Defragment the Hard Drive
USB/FireWire Diagnostics
The Endeavor CR, VikingQuest and VikingSelect
systems contain built-in diagnostic programs that allow
comprehensive testing of the system’s amplifier and
stimulator modules
3. Double click on the System Log icon to
expand the list. Review the list to see if
there is a pattern of warnings or errors
present.
4. Double click on each warning and error to
view detailed information about the log
entry and to access links to troubleshooting
information. You can also scroll between
log entries to review them.
5. Repeat steps 3 and 4 for the Application log.
6. Review and investigate the causes for any
Warning or Error entries, or patterns of
entries, and try to resolve them.
You may wish to contact VIASYS
Customer Care for help.
Step Action
1. From the XP desktop, double click on My
Computer. Right click on Local Disk (C:)
and select Properties from the drop-down
menu.
2. In the Local Disk (C:) Properties window,
General tab, verify that the Free Space is
greater than 25%. If the Free Space is less
than 25%, archive and delete the patient
exam files on the hard drive before
proceeding further.
3. Click on the Tools tab to bring it to the
forefront. In the Error checking panel, click
on Check Now. The Check Disk (C:)
window opens. Leave both check boxes
empty and click on Start. When the process
finishes without errors, the system displays
a Disk Check Complete window.
4. Click on OK to close the completion
window.
5. If you encountered errors, run the check
disk utility again, this time with both Check
disk option boxes check marked. This will
require you to reboot the system.
Step Action
Step Action
1. If necessary, re-open the Local Disk (C:)
/Properties window.
2. Click on the Tools tab to bring it to the
forefront. In the Defragmentation panel,
click on Defragment Now. The Disk
Defragmenter window opens. Click on
Analyze to determine if defragmentation is
necessary. If recommended, click on
Defragment.
NOTE:
Due to the large capacity of the hard drive, the
defragmentation process may take a significant
amount of time to finish, typically 20 minutes to an
hour. A completion window appears when the
process finishes.
3. Click on OK to close the completion
window. Click on OK to close the Local
Disk (C:) Properties window.
Step Action
1. From the desktop, double-click on the USB
or FireWire Diagnostics icon.
2. Refer to Chapter 6:Troubleshooting for
instructions on running and interpreting the
USB or FireWire diagnostics for your
system. Verify that all tests passed.