Service manual

Revision 2/18/05 5 - 1
System Procedures
Chapter 5
Introduction
This chapter contains detailed procedures required for
the installation, verification, maintenance and repair of
the Endeavor CR, VikingQuest, and VikingSelect
instruments. The procedures are ordered from the most
commonly performed to the least commonly used.
System Verification Checklist &
Procedures
Use this checklist and the associated functional
procedures to verify the system is working properly.
Routine Backup and Maintenance
Procedures
These procedures are routinely performed by instrument
operators and hospital service personnel.
VIASYS Software Loading Procedures
Set up Windows XP Display and Desktop
Properties
This section describes the steps necessary to optimize
Windows XP for use with the VIASYS applications.
System Drivers
This section covers the loading and configuration of
network and printer drivers.
MS Office (option)
This section covers the steps required to install
Microsoft Office (optional) for report generation on the
VikingQuest and VikingSelect.
NicVue (option)
This section covers the steps required to install and
license the NicVue Patient Database Administrator
(optional).
Endeavor CR Application
This section covers the steps required to install the
Endeavor CR application package.
VikingQuest Application
This section covers the steps required to install the
VikingQuest and VikingSelect application package.
VikingSelect Application
This section covers the steps required to install the
VikingSelect application package.
Setup NicVue
This section describes the steps required to set up a new
Nicolet-only network and configure it to run NicVue.
Windows XP Repair Procedures
This section describes how to restore a previous set
point in Windows XP and how to perform a repair of the
Windows XP operating system.
Windows XP Load
This section describes how to perform a complete load
of Windows XP using the computer vendor’s Windows
XP CD.