Service manual

Neurodiagnostic Instruments Service Manual
1 - 4 Revision 2/18/05
VIASYS NEUROCARE HAS TAKEN
REASONABLE MEASURES TO ENSURE THAT
VIASYS SOFTWARE WILL REMAIN
UNAFFECTED BY THE PRESENCE OF OTHER,
THIRD-PARTY SOFTWARE PROGRAMS.
HOWEVER, GIVEN THE VAST NUMBER OF
SOFTWARE PROGRAMS AVAILABLE, VIASYS
NEUROCARE CANNOT ENSURE COMPLETE
IMMUNITY, NOR CAN VIASYS NEUROCARE
GUARANTEE IMMUNITY AGAINST
SOFTWARE VIRUSES.
ANY USER WHO INSTALLS THIRD-PARTY
SOFTWARE ON A VIASYS INSTRUMENT OR
ALTERS VIASYS SOFTWARE CODE ASSUMES
ALL RISKS AND LIABILITIES IN DOING SO.
THE USER WILL BE SUBJECT TO SERVICE
CHARGES TO RESTORE THE SYSTEM TO
NORMAL OPERATION, EVEN IF THE SYSTEM
IS WITHIN THE WARRANTY PERIOD OR
UNDER SERVICE CONTRACT.
Consult a qualified VIASYS Service Representative
before reinstalling the system software. Records can
be destroyed. Follow the steps in the installation
procedure only with the direction of a qualified
Service Representative.
Federal US and Canada law restricts this device to
sale by or on the order of a medical practitioner
licensed by the law of the state in which they practice
to use or order the use of this device.
Proper use of this device depends on careful reading
of all instructions and labels.
Do not touch the monitor screen with your fingers.
You can create a static charge that may affect the
display.
Follow all safety standards set by your place of
employment
The isolation transformer is a 100, 110, 220 or 240
volt input. Plug its power supply cable only into a
100, 110, 220 or 240 volt external (wall) outlet.
Approved Electrodes: Use only VIASYS
approved/supplied electrodes and transducers. See
your VIASYS Distributor or call 1-800-356-0007 in
the USA. Use of non-approved electrodes or
transducers might adversely affect the function of
your system.
Electrical shock hazard. Do not remove cover. Refer
servicing to qualified service personnel.
Do not overtighten connector securing screws. You
may damage components. Hand-tighten all securing
screws, or use a small flathead screwdriver with
minimum torque.