User`s manual

2-4 Install Memory

This motherboard provides three 168-pin DUAL INLINE MEMORY MODULES (DIMM)

sites for memory expansion available from minimum memory size of 32MB to maximum

memory size of 1.5GB SDRAM.

Valid Memory Configurations

Bank 168-Pin DIMM Total Memory

Bank 0, 1 (DIMM1) SDRAM 32, 64, 128, 256, 512MB X1

32MB∼512MB

Bank 2, 3 (DIMM2) SDRAM 32, 64, 128, 256, 512MB X1

32MB∼512MB

Bank 4, 5 (DIMM3) SDRAM 32, 64, 128, 256, 512MB X1

32MB∼512MB

Total System Memory (Max. 1.5GB)

32MB∼1.5GB

NOTE! Make sure the total installed memory does not exceeds 1.5GB, otherwise the

system may hang during startup.

Generally, installing SDRAM modules to your motherboard is very easy, you can refer to

figure 2-4 to see what a 168-Pin PC100 & PC133 SDRAM module looks like.

DIMM3 (BANK4+BANK5)

DIMM2 (BANK2+BANK3)

DIMM1 (BANK0+BANK1)

NOTE! When you install DIMM module fully into the DIMM socket the eject tab should be

locked into the DIMM module very fimly and fit into its indention on both sides.

WARNING! For the SDRAM CLOCK is set at 133MHz, use only PC133-compliant

DIMMs. When this motherboard operate at 133Mhz, most system will not even

boot if non-compliant modules are used because of the strick timing issues, if

your DIMM are not PC133-compliant, set the SDRAM clock to 100MHz to

ensure system stability.

Figure 2-4