Owner`s manual

14
What to Expect
The airbag should exit the backpack and fill completely in approximately three seconds. The airbag
will continue to build pressure for a few seconds longer until the system pressure equalizes. The
airbag will hold air for several minutes until the threat of an avalanche has passed.
After Deployment
Release the air from the airbag by pressing the release valve with your finger. The valve is located
underneath the orange release valve cover
14
. Do not use hard or sharp objects to hold the release
valve open, as they could damage the valve-sealing surface. Re-pack the airbag into the airbag
compartment. See “Packing the Airbag” below for details.
The Float airbag will not deploy again until the cylinder is refilled or replaced. This can be done at a
Float Refill Center (see www.backcountryaccess.com/refillcenters). To install the charged cylinder,
see “Installing Compressed Air Cylinder” on page 10. If you have deployed your airbag in an
avalanche, please contact BCA for a free airbag inspection and cylinder refill.
Packing the Airbag
The airbag must be folded into the airbag compartment. DO NOT ROLL OR STUFF THE AIRBAG OR
THE SYSTEM MAY NOT DEPLOY PROPERLY. If the airbag is wet, dry it completely before packing.
Empty any residual air from the airbag using the release valve (you may need to do this periodically as you
pack the bag). It is very important that all residual air has been released. After this air has been released,
disconnect the air hose from the cylinder before folding the airbag.
1. Completely separate the zipper so the slider is only attached to one set of teeth.
2. Bring zipper slider back to the opposite side of pack where the zipper
begins (a).
3. Begin by laying out the deflated airbag flat on the ground. Make one
vertical accordion fold on each side of the airbag (b).
4. Next make two horizontal accordion folds on the airbag (c). After this step
your airbag is ready to be zipped inside the airbag compartment.
5. With airbag folded inside the compartment, re-engage the zipper (d)
and zip the compartment past the Velcro flap at the top of the compartment (e). Fasten Velcro and finish
zipping the compartment closed (f).
6. Refill or exchange your empty cylinder before using your Float pack again.
d)
e)
f)
b)
c)
Using the Avalanche Airbag
a)