User`s manual

TS Series Time Stamp User’s Manual
Page 7
SETTING THE DIGITAL DISPLAY
Models with a "C" affixed to their designation (TS50C and TS80C) denote units featuring a
digital display. This display is factory-set for use in the 12-hour AM/PM format or the 24-hour
(Continental) format. The digital display should always be synchronized with the time type
wheels. To set the digital display and synchronize the display with the time type wheels, do the
following:
1. Connect the power source.
2. Locate the three (3) push-buttons labeled SEC,
HRS and MIN on the bottom of unit (Figure 3).
3. Return the unit to its upright position with the
digital display facing towards you. Pull the unit
forward slightly so the front hangs over the
edge of the table, thereby giving you access to
the buttons. (Remember: The minute button is
on the right.)
4. Make a registration to see what time is indicated by the time stamp. Use the HRS (center)
and MIN (right) buttons to set the time to the hour and minute indicated on the
registration.
5. Place your finger on the minute button (right) but do not press it just yet. Listen for the
type section to advance; you will hear an audible click. When you hear the click,
immediately press the minute button to advance one minute. Seconds are now
synchronized with the type section.
6. Make another registration to check the imprint feature for accuracy.
Note: Interruptions in power lasting more than 3 to 5 seconds will cause the digital display
to flash, indicating that it is necessary to reset the display.
Figure 3