User`s manual

TS Series Time Stamp User’s Manual
Page 6
SETTING THE TYPE WHEELS
As noted in the earlier sections TS SERIES MODELS and OPTIONAL FEATURES, the TS Series
Models are available with a variety of date, time, and number wheels. You may set the
applicable type wheels according to the following directions.
1. Disconnect the power source.
2. Remove the top cover by inserting the key in the back of the unit, turning the key
clockwise, and pulling the cover up and forward.
3. Remove the frame locking pin (Figure 2, Number 1). Lift the top frame (Figure 2, Number
2) to access time and date type wheels (Figure 2, Number 3) and number type wheels, if
applicable.
4. Depress the time type setting lever (Figure 2, Number 4). Using a small screwdriver or
similar tool, rotate each individual date and time type wheel down to the correct date and
time. (Note: Month and date type wheels must be reset manually the first day of each
month.)
5. Depress the number type setting lever (Figure 2, Number 5) and rotate the number type
wheels (Figure 2, Number 6) to the correct
position.
6. Close the top frame and insert the locking pin,
positioning the pull ring down and inside the case.
Reinstall the top cover, fitting the top securely into
the grooves in the main frame case. Lock the top
in place.
7. Connect the power source.
8. Make a registration to check for accurate date,
time, and number readings. If necessary, reset the
digital display. (See Page 7.)
Figure 2