User`s manual

TS Series Time Stamp User’s Manual

Page 5

GETTING STARTED

Getting started with the TS Series is easy. There are only a couple of fundamental decisions

that must be made.

1. Plug the unit into the wall outlet

2. Place the clock on top of the anti-skid rubber pad (included)

3. Set the type section

4. Set the digital clock (optional feature)

INSTALLATION

The TS Series time stamp installs easily on any tabletop or flat surface. Determine whether you

have a 110/120 VAC or 220 VAC unit, then plug it into any appropriate AC wall outlet. (Note:

Avoid outlets with On/Off switches. These outlets may be accidentally turned off, causing an

interruption of the timing action.)

REGISTRATION

When forms are fully inserted into the stamp, an automatic trigger causes registration. If the

optional manual registration button is installed, insert a form to the desired position by

aligning the desired registration position with the print locators (Figure 1, Number 1) on the

side of the case. When the form is aligned, press the manual registration button on the front

of the unit (Figure 1, Number 2).

Figure 1