User`s manual

TS Series Time Stamp User’s Manual
Page 13
CHANGING THE PLATEN
1. Disconnect the power source.
2. Remove the top cover. Remove the frame locking pin
and lift the top frame. Remove the ribbon (see
Changing the Ribbon, Page 11).
3. Lift the printing platen assembly up and out of the
frame. (Figure 10)
4. Insert the alternate printing platen assembly, using
the guide pin for alignment.
5. Replace the ribbon. Close the top frame and install
the frame locking pin. Install the top cover.
6. Connect the power source.
7. Make a sample registration. Reset the time type
wheels and the digital display.
Figure 10