User`s manual

TS Series Time Stamp User’s Manual
Page 11
CHANGING THE RIBBON
TS Series time stamps use a silk ribbon for long-lasting, high-quality imprints. To avoid
damaging the unit, use only 1307-5008 (purple), 1307-5009 (red) or 1307-5010 (black) ribbon.
To change the ribbon:
1. Disconnect the power source.
2. Remove the top cover. Remove the frame
locking pin and lift the top frame (as described
on Page 6, Figure 2).
3. Pull the front spool plunger knob (Figure 8,
Number 1) away from unit. While holding the
knob, slide the ribbon to the left and out.
4. Release the spool plunger knob.
5. Repeat steps 3 and 4 with rear spool plunger
knob. Remove and discard the used ribbon.
6. Pull the front plunger knob out and position
the new ribbon as shown in Figure 8. Align
the spool with the posts on the ribbon spindle
shaft and the spool plunger (Figure 8,
Numbers 2 and 1).
7. Release the spool plunger knob.
8. Repeat steps 6 and 7 with the rear spool
plunger knob.
9. Close the top frame and install the locking pin.
Install the top cover.
10. Connect the power source.
11. Make a sample registration. Reset the type wheels (Setting the Type Wheels, Page 6) and
the digital display (Setting the Digital Display, Page 7).
Figure 8