Operating instructions

RQT8152
7
Getting started
STEP 1 Connection
• The equipment connections described are examples. Visit Panasonic’s homepage for more information about connection methods. (This is
in English only.)
http://www.panasonic.com/consumer_electronics/dvd_recorder/dvd_connection.asp
• Before doing any connection, turn off all equipment and read the appropriate operating instructions.
• Peripheral equipment and optional cables are sold separately unless otherwise indicated.
The connection will allow the video cassette recorder to be used for
playback when this unit is turned off. For optimum operation, it is
recommended that this unit be connected as shown below.
n When the unit is not to be used for a long time
To save power, unplug it from the household AC outlet. This unit
consumes a small amount of power, even when it is turned off
(approx. 15.7 W).
Connect the unit directly to the television
Video signals fed through video cassette recorders will be affected
by copyright protection systems and the picture will not be shown
correctly on the television.
• When connecting to a television with a built in VCR, connect to the
input terminals on the television side, not the VCR side.
n Quick Start (Ô page 32)
1 Sec. Quick Start for Recording on DVD-RAM*
*From the power off state, recording on DVD-RAM starts about 1
second after first pressing [POWER 8] and then sequentially
pressing [* REC] (Quick Start).
Connection with a television and video cassette recorder
RF
IN
VHF/UHF
RF IN
VHF/UHF
RF OUT
AUDIO
R
AUDIO
L
VIDEO
IN
AUDIO
R
AUDIO
L
VIDEO
OUT
OUT IN
VHF/UHF
RF IN
AUDIO IN
R L
VIDEO
IN
1
2
3
4
5
6
indicates included accessories.
indicates accessories not included.
AC power supply cord
Connect only after all other
connections are complete.
To household
AC outlet
(AC 120V, 60 Hz)
Television
Red White Yellow
Audio/Video
cable
75 Ω coaxial cable
Video cassette recorder
Audio/Video cable
Cable from wall
or antenna signal
Red White Yellow
Red White Yellow
Red
White
Yellow
75 Ω coaxial cable
The unit’s RF OUT terminal
The picture and sound signal from this unit does not go through
the RF OUT terminal to the television.
Make sure you connect one of the following terminals on this
unit to the television: the AUDIO/VIDEO OUT terminal, the S
VIDEO OUT terminal or the COMPONENT VIDEO OUT
terminal.
• Refer to page 9 if the antenna connector doesn’t match.
This unit
75 Ω coaxial cable
Cooling fan
If your television does not have
AUDIO/VIDEO terminals, an RF
modulator is necessary. Consult your
local dealer for more information.
To IN 1
Televi sio n
This unit
VCR
Television
VCR
This unit
n To enjoy even higher picture quality
You can enjoy even higher picture quality, if your television has an
S VIDEO IN or COMPONENT VIDEO IN terminal. (Ô page 8)
DMR-ES20-P10_1.fm 7 ページ ２００５年８月３１日 水曜日 午前１１時４４分