Specifications

XEN Topaz NEC Business Solutions Ltd
Features and Specifications Manual Chapter 4 - 311
Doc. No. 8846 - Release 2.0 April 2005
Time and Date
• Description
The system Time and Date for:
Conditions
• The system retains the Time and Date after a power failure or system
reset.
• The system can automatically adjust for daylight savings time if desired.
• The date must be set in system programming.
Default Setting
Enabled.
• Programming
10-01-01: Time and Date
Set the system Time and Date from your administrator’s telephone.
10-24 : Daylight Saving Setup
20-02-07: System Options for System Telephones - Time and Date Display
Mode
Select the display mode (type 1-8) for Time and Date (i.e., Time and
Date format).
20-06-01: Class of Service for Extensions
Assign a Class Of Service (1-15) to an extension.
20-07-03: Class of Service Options (Administrator Level) - Time and Date
In an extension’s Class of Service, enable (1) or disable (0) the exten-
sion’s ability to set the Time and Date.
• Related Features
• Class of Service
Changing the time may change the current COS service depending on the COS
mode setup.
• Single Line Telephones
Single line telephones cannot set the Time and Date.
•Operation
To set the system Time:
• Central Office Calls (Access Maps)
• Class of Service (Class)
• Direct Inward Lines
• Display Telephones
• Fax Machine Compatibility
• Night Service (Automatic)
• Programmable Trunk Parameters
• Ring Groups
• Station Message Detail Recording
• System Reports
• Toll Restriction (Class)
• Trunk Group Routing
• Voice Response System