Specifications

XEN Topaz NEC Business Solutions Ltd
Features and Specifications Manual Chapter 4 - 211
Doc. No. 8846 - Release 2.0 April 2005
For Outgoing Line Preference and Auto-Answer of Non-Ringing Lines,
set up the Trunk Access Maps (1-51).
15-01-02: Basic Extension Data Setup - Outgoing Trunk Line Preference
Enable (1) or disable (0) Outgoing Trunk Line Preference for extensions.
15-02-09: System Telephone Basic Data Setup - Ringing Line Preference for
Intercom Calls
Enable Idle (0) or Ringing (1) Line Preference for Intercom calls. See the
table below for interaction.
15-02-10: System Telephone Basic Data Setup - Ringing Line Preference for
Trunk Calls
Enable Idle (0) or Ringing (1) Line Preference for trunk calls. See the
table below for interaction.
15-06-01: Trunk Access Map for Extensions
For Outgoing Line Preference and Auto-Answer of Non-Ringing Lines,
assign trunk Access Maps to extensions.
20-10-07: Class of Service Options (Answer Service) - Automatic Answer of
Universal Calls
Enable (1) or disable (0) an extension’s ability to use Universal Auto
Answer for non-ringing lines.
22-01-01: System Options for Incoming Calls - Incoming Call Priority
Determine if ringing Intercom calls (0) or ringing trunk calls (1) should
have answer priority. See the table below for interaction.
22-04-01: Incoming Extension Ring Group Assignment
Assign extensions to ring groups (1-25). Auto-Answer for Non-Ringing
Lines only works for trunks that do not ring an extension.
22-05-01: Incoming Trunk Ring Group Assignment
Assign trunks to ring groups (1-25). Auto-Answer for Non-Ringing Lines
only works for trunks that do not ring an extension.
23-03-01: Universal Answer/Auto Answer
For each extension, select the route that it will use for Auto-Answer for
Non-Ringing Lines. The routes correspond to the Trunk Group Routing
table set in Program 14-06.
• Related Features
• Direct Inward Line
DILs do not affect Incoming Line Preference operation.
• Ring Groups
Trunks ring extensions according to Ring Group programming.
• Trunk Group Routing
If an extension gets trunk dial tone when the user lifts the handset, the system
uses the “dial 0” routing to select the trunk.
•Operation
To answer a ringing call if your phone has Ringing Line Preference:
1. Refer to the chart on the previous page.