User manual

32
TEMPERATURE SIMULATION: (NIBP-1030 Only)
The temperature setting can be selected in the SETUP mode. This fixed value will remain
on the Temperature output until changed. The output will simulate both YSI 400 and YSI
700 Temperature probes.
NOTE: Both outputs are available at the output connector simultaneously.
NOTE: On some Patient Monitors, if ECG simulation is active on the NIBP-1030 and you
enable Temperature Simulation, the ECG trace may disappear from the Patient Monitor
screen. This is a flaw of the Patient Monitor, not the NIBP-1030 Simulator.