User manual

Connecting IBP Cables (NIBP-1030 ONLY)

For models with IBP output, connect the DUT-appropriate IBP test cable between the

NIBP-1030 IBP Connector (6-pin Mini-DIN as pictured below) and the DUT. The pin-out

shown below for the Mini-DIN connector is the industry standard configuration used on

most modern patient simulators. As such, there are many existing cables that may be

used or you may obtain the proper cable from BC Group.

NOTE: Mini-DIN pinout viewed from NIBP Connector Side

Connecting Temperature Simulation Cables (NIBP-1030 ONLY)

For the models with Temperature output, connect the DUT-appropriate Temperature

Simulation test cable between the NIBP-1030 Temperature Connector (8-pin Mini-DIN as

pictured below) and the DUT.

NOTE: Mini-DIN pinout viewed from NIBP Connector Side