Installation guide

CTI/1 Manual V1 Dec 08 3
INTRODUCTION
GENERAL
The CTI/1 is designed to provide conversion from RS422/485 serial data to BBV
Coax Telemetry based systems.
Up the Coax telemetry allows upgrading of static cameras to PTZ without the
need for additional cabling.
The RS422/485 input is auto detecting. The CTI/1 will understand BBV RS422
@ 9600 N, 8, 1. & Pelco P @ 9600, N, 8, 1.
1 x BNC output provides Coax Telemetry, connecting to a single receiver.
1 x BNC output provides Video Loop Through.
Each unit is supplied with a 9v 500mA Power Supply, Manual & Adhesive
Fixings.
Please Note: The CTI/1 supports eight addresses only
Protocols currently supported are: BBV & Pelco P
The CTI/1 has been tested with the BBV FBM Matrix, BBV TX1500 Matrix, BBV
TX400DC/RS485 & Pelco KBD300,
The following pages show address settings and connection details.