Installation guide

162
For IVT-16 Key Telephone
The following table shows the commands for accessing the special features. Your System Manager
may have confi gured your system to require the “*” key to be pressed before dialing sequences
beginning with a ‘4’ or ‘5’ digit.
Pg# Sequence Description
56 From the Operator station only, set Night mode.
57 From the Operator station only, set Day mode.
147 DSS or 1 nn Place an intercom call to extension or to one of the Hunt
Groups.
148 3 Pick up an intercom call ringing at another extension.
150 CO 1 to 4 Retrieve CO calls placed on hold.
153 FWD, DSS Forward all calls from this extension to another extension.
153 FWD Cancel the forwarding of calls from this extension.
154 43, DSS Forward all calls from another extension to this extension
(Follow Me).
154 53, DSS Cancel calls being forwarded from another extension to this
extension. (Clear Follow Me)
154 40 nnnnnn Enter the 6-digit Call Unbarring Password.
155 59 Force this extension to use the restricted calling list.
155 50 nnnnnn The correct password “nnnnnn” will cause this extension to no
longer use the restricted calling list.
156 410 Connect to pager output.
156 411 Connect to the key telephones and door phones in
Pager Group #1 and to the pager output.
156 412 Connect to the key telephones and door phones in Pager Group #2.
156 MSG, DSS Turn on the message light / command at another extension.
157 55, DSS Turn off the message light / command at another extension.
157 DND Place the phone at this extension into the Do Not Disturb
mode.
157 DND Take the phone at this extension out of the Do Not Disturb
mode.
158 45, hh, mm Set the alarm clock for ‘hh’ hours (0 to 23) and ‘mm’ minutes
(0 to 59).
158 46 Cancel the alarm clock setting.
158 49 Start the Emergency Alarm signal to all extensions.
159 MEM nn Place an outside call using one of the speed dial numbers.
Dialing Code Sequences
Dialing Code Sequences