Installation guide

96
8. Enter the “pulse dialing make time” code:
0 24 milliseconds
* 1 32 milliseconds
2 40 milliseconds
3 48 milliseconds
4 56 milliseconds
5 64 milliseconds
6 72 milliseconds
7 80 milliseconds
8 88 milliseconds
9 96 milliseconds
7. Enter the “pulse dialing break time” code:
0 48 milliseconds
1 56 milliseconds
* 2 64 milliseconds
3 72 milliseconds
4 80 milliseconds
5 88 milliseconds
6 96 milliseconds
7 104 milliseconds
8 112 milliseconds
9 120 milliseconds
Pulse Dialing Timing
These settings relate to pulse mode dialing only. Break time is the time for generating a single
pulse; it is the amount of time the line goes on hook to send a dial pulse. Make time is the off hook
time between dial pulses.
Chapter 3 - Functions Of IPS System
System Timing Parameters