FORCE V USER MANUAL BROTHER, BROTHER & SONS ApS software v: 1_3_00 / hardware v. 10 / user manual v. 1.
FORCE V USER MANUAL INTRO Brother, Brother & Sons ApS The information in this manual is subject to change without notice. Go to www.brothers-sons.dk for the latest version. Brother, Brother & Sons ApS assumes no responsibility for any errors or inaccuracies that may appear in this manual. All information and graphics are the property of Brother, Brother & Sons ApS. Customer and Warranty service: Contact your regional dealer. Contact information for your area can be found at www.brotherssons.
FORCE V USER MANUAL CONTENTS Intro.......................................................................................................................... Index.......................................................................................................................... Safety Information...................................................................................................... Maintenance.............................................................................................
FORCE V USER MANUAL SAFETY Safety Notice: It is important to read ALL safety information and instructions in this manual before installing and operating the product described. Safety symbol used in this manual: WARNING: Potential injury or damage to persons or product. WARNING: It is important to read ALL safety and installation instructions to avoid any damage to the product and potential injury to yourself and others. This product is for professional use only and has been designed for indoor use.
FORCE V USER MANUAL PRODUCT OVERVIEW DMX IN DMX OUT TILT LOCK TUBUS LOCK TAB TUBUS LOCK TAB PowerCon OUT TUBUS ROTATION LOCK 416,32 320 PowerCon IN 285,88 350,18 WWW.BROTHERS-SONS.DK software v: 1_3_00 / hardware v. 10 / user manual v. 1.
FORCE V USER MANUAL INSTALLATION Do not operate the product if the ambient temperature exceeds 40° C / 104°F Provide a minimum clearance of 0,1m (4 in.) around fans and air vents. This fixture must be connected to ground. This fixture is for indoor use only. Read the “Safety” and “Specifications” chapters first. Applying power: Never connect to dimmer power. Make sure the local power voltage is within the range specified. If so; connect a power cable and turn the power on.
FORCE V USER MANUAL MOUNTING THE TUBUS ON THE FORCE V Place the Tubus on a flat surface. Loosen the Tubus Rotation Lock knob by turning counterclockwise. Lower the Force V on to the Tubus with the contours aligned (dashed lines). Press slightly down on the Force V while turning it counterclockwise until the Force V drops into place. Turn the Force V clockwise until the lock tabs snaps into place. Tighten the Tubus Rotation Lock knob by turning it clockwise.
FORCE V USER MANUAL ROTATING THE TUBUS Loosen Tubus Lock and turn the tubus into the desired position and lock it again. WWW.BROTHERS-SONS.DK software v: 1_3_00 / hardware v. 10 / user manual v. 1.
FORCE V USER MANUAL AC Power This fixture must be connected to ground. Electrical: AC Power: 100 – 240 V nominal, 50/60 Hz Powersupply: Electronic switchmode Max power consumption: 137 w DMX Data link This product uses a 5-pin XLR for dmx input and output. Use shielded data cables. Do not overload the daisy chain. Up to a maximum of 32 devices can be used on a single dmx chain. DMX Channels: 1 at 8bit: Dimmer 3 at 8bit: Dimmer w. strobe 2 at 16bit: Dimmer 4 at 16bit: Dimmer w.
FORCE V Software vers. 1_3_00 Linear curve on Indicator USER MANUAL Response fast indicator Strobe on Indicator 8 bit Indicator 888888 MENU ENTER UP DOWN DMX present indicator Open menu / Go back Select / Confirm Scrolling UP / Increase value Scrolling DOWN / Decrease value DMX Channels Mode Channel Parameter Value Percent Function 8 Bit 1 Dimmer 0 - 255 0 - 100 Coarse dimming 8 Bit w.
FORCE V USER MANUAL Software vers.
FORCE V USER MANUAL Software vers. 1_3_00 SOFTWARE MENU ....continued Default values indicated by bold font Log Max Fan Fan RPS EEProm LED U PSU U LED int Log C° on time on LED Demo DMX HZ DMX CH DMX br LED EE Manual 0 Maximum fan speed logged. (in RPS) - READOUT ONLY Current fan speed (in RPS) - READOUT ONLY Developer info LED voltage in Volts - READOUT ONLY PSU voltage in Volts - READOUT ONLY for troubleshooting - READOUT ONLY Minimum and maximum logged temperature in °C UP and DOWN scrolls min.
FORCE V USER MANUAL FAQ - TROUBLESHOOTING To be implemented Brother, Brother & Sons ApS - The information in this manual is subject to change without notice. Go to www.brothers-sons.dk for the latest version. WWW.BROTHERS-SONS.DK software v: 1_3_00 / hardware v. 10 / user manual v. 1.
FORCE V USER MANUAL SPECIFICATIONS Physical: (Force V NOT attached to tubus) Depth: 350,18 mm / 13,79” Width: 239,50 mm / 9,43” Height: 416,32 mm / 16,39” Weight: 6,5 kg / 14,33 lbs Data: DMX Channels: 1 or 3 at 8bit: 2 or 4 at 16bit: Protocol: USITT DMX512-A Electrical: Never connect to dimmer power AC Power: 100 – 240 V nominal, 50/60 Hz Powersupply: Electronic switchmode Max. power consumption: 137 W. This fixture must be connected to ground. Thermal: Maximum ambient temperature - t.
