Owners manual

WWW.BBKPERFORMANCE.COM
FOLLOW THESE INSTRUCTIONS CAREFULLY TO ENSURE CORRECT FITMENT AND OPERATION
UPDATED LAST: April 2018
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
[e-mail]
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
MADE IN U.S.A.
STEP 10
Remove the (2) bolts that hold
the connect rod for the steering
shaft. Once the (2) bolts are
removed push the connecting
rod towards the re wall until the
connecting rod releases from
the rack and opinion end then
you may slid the connecting rod
towards the front of the vehicle
to release it from the steering
shaft and remove it from the
vehicle. From underneath the
vehicle take a measuring tape to use as a guide line to mark where the exhaust
will be cut. Stick the end of the measuring tape into the hole in between the (2)
transmission cross member bolts and hold it straight up and down and mark
the exhaust pipe on the side of the tape measure that is closest to the front
of the vehicle do this on the driver and passenger side of the exhaust. Using a
saw’s all cut the exhaust pipes where you had made the marks.
NOTE: you may need some help having someone hold the exhaust so that it
does not bobble around. This is what the exhaust should look like once it is cut
out. See g 1-2.
STEP 9
Remove the (4) bolts that hold the catted down pipe to the collector on the
exhaust manifold do this for both driver and passenger sides. Support the
exhaust system so that it does not fall down. Remove the (4) bolts from the
exhaust cross member bracket and remove it from the vehicle. Release the
exhaust system to let it drop down and rest on the chassis cross brace.